How to install drip edge?
There are many good roofing and construction materials that are necessary to provide the best protection against water damage. Of all things, the first line of defense is to install drip edge flashing. Unfortunately, many entrepreneurs ignore this step. so, one should hire a good roofing solution in Bangalore to complete the task
Deleting this installation may
end up being your nightmare in the future. So, if you're renovating your home,
be sure to look for a gutter. If your roof is finished (without gutters), you
can still install gutters.
What is Drip Edge Flashing?
Drip Edge is a flashing strip
that is applied to the edge of the house before installing other materials. It
is designed to protect the roof from water damage caused by rain, snow, or ice
that blows or is forced under the edge of the shingles. When installed on the
surface of the roof, the drip edge will prevent capillary water damage caused
by surface tension. When placed next to the rakes, it protects the liner from
the wind being driven (or forced) back into the liner.
How to Install Drip Edge
Flashing on a New Roof
To install gutters on a newly
constructed roof or during renovations, first install the gutters on the front
side of the roof. The eaves must extend at least 2 inches above the roof. This
is where the vertical leg should be placed 1/4" - 1/2" from the fascia.
Leaving a gap between the fascia
and the gutter is a common mistake made by contractors. It's not common for
them to put a drip tray just against the fascia.
This will cause tension to flow
back into the fascia. The bottom line is that it quickly destroys the wood. So,
make sure you have that space. Then, turn and install the cover or effect.
Proper lamination is to install the membrane above the drain spout on the eve
and below the drip spout for the slope.
If you are looking for latest roofing designs in India then you can visit our website.
Comments
Post a Comment